An Easy BDSM DIY Gag

I saw this pacifier gag on Etsy, and thought, I could make that (pictured below)!

If you don’t have the time or patience for BDSM craft projects you could just order this item and be done with it, but I had just picked up a couple pacifiers for my dungeon, so I figured I would just make one into a gag.

I sat down with my tools, rivets and a very skinny belt only to realize my pacifier didn’t have the same slots as the one pictured on Etsy (above). Mine had smaller circular holes, so I would either have to cut slots in the plastic, or abandon the belt idea. I wasn’t in a patient mood, so I ditched the belt.

I decided to take a quicker, less pretty, but still functional route. Instead, I opted for paracord rope with a little plastic cincher like you find on jacket hoods. I could have done some nifty knot work along the sides, similar to a paracord bracelet, but again, I was not in a patient mood, so I just used a single paracord strand on each side. My crude, but functional version is pictured below.

You simply put the cord through the hole in whatever crude or fancy way you like, then measure the length of the paracord by putting it around your head to ensure it will fit around someone else’s head. Use a lighter to melt the ends of the paracord strands. Try to keep the ends of the melted paracord rope skinny so they will slip through the plastic cincher. Two strands of paracord through this type of plastic cincher can be a pretty tight fit. (If you heat it short bursts you won’t burn your finger while shaping the ends.) Once I threaded each paracord strand through the plastic cincher, I tied knots at the ends so they could not slip back through the clincher. That would be a time waster to re-thread during a session. I then heated my knots with a lighter to melt the knot a little. It is less likely to come untied that way. You could also dip the knots in a plasti-dip coating if you were so inclined. I wasn’t.

That’s it. You now have a pacifier that you can slip over your sub’s head and cinch up in a jiffy! No buckles, no incorrectly spaced holes. No need to add extra holes to the leather. Just zip it snug and move on. Easy peasy!

The cost to order the pretty version is $26.32 plus shipping. For mine, I obtained two pacifiers for $1 at Dollar Tree, you can also get 25ft of paracord there for $1. I already had a package of plastic cinchers I purchased from the sewing section in Michael’s. They are also available cheap on Amazon as seen on the picture below, or free if you take one off an old jacket hood. I’m going to guess my pacifier gag cost me about $3 (no shipping), with supplies leftover if I wanted to make more. : )